A family roofing company serving Burr and the rest of Nebraska through our network of local crews. Tin roofs, repairs and replacements done right.
Pick a service to see how we handle it and what the job usually looks like on a Burr roof.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
Not every hailstorm ruins a roof. We look before we tell you anything, and if the damage is only cosmetic we will say that too.
We repair standing seam, exposed fastener panels and metal shingles, and we match the color as closely as the paint system will allow.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
A metal roof is the one that outlives the mortgage. We install exposed fastener panels and standing seam over solid decking and real underlayment, with around twenty standard colors to choose from.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Temporary cover goes on fast, then we come back and make the permanent repair once we can see properly what we are working with.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
Small repairs get the same crew and the same care as a full roof. Free estimate, a price in writing, and the work done before the next rain moves in.
Reflective coatings keep a metal roof cooler in summer and seal up the small stuff before it turns into a leak.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Removing the ice is the easy half. We also look at ventilation and insulation so it stops happening every January.
Roofing Brothers began in 2002 as a family roofing company in Morganton, North Carolina, and it is still run the way it started. Homeowners in Burr reach that same outfit — the one that has been setting metal panels and laying shingles for over twenty years — through our network of local crews.
In a city the size of Burr, word travels fast about who does good work and who does not. That suits us fine. We would rather put one roof on right and have the neighbors ask about it than chase volume all over Nebraska.
Nothing fancy — free estimates, honest answers, and roofs that go on straight.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
Common questions from Burr, NE homeowners about metal roofs, repairs and what a roof costs.
Much less than people expect. Over solid decking with underlayment under it, a Burr metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
No. Estimates are always free in Burr. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
A typical Burr shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Often, yes. Plenty of the Burr roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
We do. After a storm we photograph the damage on your Burr roof and write an itemized estimate you can hand to your adjuster. We do not file the claim for you and we will not promise you what an adjuster is going to approve — that is their call, not ours.
Most Burr houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
We would rather let the work, and the people who paid for it, do the talking.
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Wind peeled up the edge of our roof and they came out that same evening to cover it so the rain would not get in. Permanent repair the following week."
Looking for a roofer just outside Burr? These areas are covered too.